Vandex Unimortar 1 is a versatile waterproofing and repair mortar for concrete and masonry (tested in accordance with EN1504-3). It may be applied to horizontal and vertical surfaces using a trowel. Spray application is also possible.
Vandex Super is a cement-based waterproofing slurry specifically designed for concrete waterproofing applications. It is mixed with water prior to application by brush or spray. When Vandex Super is applied to a concrete surface, the active chemicals combine with the free lime and moisture present in the capilliary tract to form insoluble crystalline complexes. These crystals block the capillaries and minor shrinkage cracks in the concrete to prevent any further water ingress (even under pressure). However the Vandex Super layer will still allow the passage of water vapour through the structure.
Supplied as a powder, Vandex Plug is mixed with water to form a thick paste. Once mixed, the paste is pressed into the leaking crack or hole using a trowel. After approximately 30 seconds, the Vandex Plug will have set and the leak will be sealed. The surface can then be levelled off using a levelling trowel. Vandex Plug can be used internally or externally as a waterproof plugging mortar or where rapid setting and early strength gain is required.
Visqueen Axiom CreteSeal is a low modulus structural concrete expansion joint sealant. The formulation contains both PU and silylated-PU technology resulting in a sealant which includes the best of both technologies and is easy to apply even at temperatures. It has been modified in order to give enhanced thixotropic properties.
Platon Overtape (1mm x 115mm x 25m) – Butyl rubber tape backed with non-woven polypropylene for covering joints in cavity drain membrane. Can be plastered/dot’n’dabbed over and holds membrane edges together.
A clear protective coating that can be applied to most surfaces to provide durability to existing coatings, protection of bare substrates and exceptional graffiti resistance.
Safe, environmentally friendly, fully biodegradable, non-hazardous and non- flammable. For use on all non-porous colourfast surfaces.
Vandex BB75 E is an elasticised waterproofing slurry formed by mixing Vandex BB75 Grey (dry component) with Vandex PK75 (liquid acrylic polymer). The polymer provides elasticity and enhanced crack-bridging properties to the waterproof coating, which has been tested to 7 bar (70m head of water).
Vandex BB75 is a cementitious waterproofing slurry (tanking slurry) with hydrophobic properties, resistant to water and moisture. Vandex BB75 is applied by trowel or spray to surfaces such as concrete, masonry, and render, which have to be sealed and protected against the influence of water and moisture.
Plaster Plugs Platon. Platon Plaster Plugs are used above or below ground to fix mesh cavity drain membranes to the substrate internally.
