Hydroduct® drainage sheets are pre -fabricated geo composites comprising studded polystyrene drainage cores covered with polypropylene filter fabric. They provide efficient, cost effective alternatives to traditional aggregate drainage.
Hydroduct® drainage sheets are pre -fabricated geo composites comprising studded polystyrene drainage cores covered with polypropylene filter fabric. They provide efficient, cost effective alternatives to traditional aggregate drainage.
BETEC®350 is a single component cementitious compound which is polymer modified and fibre reinforced. It is a rapid setting, high strength, waterproof compound used to seal tieholes that are created by formwork tie bars.
A 2 component flexible cementitious coating for waterproofing new and existing strutures. It comprises a liquid polymer A component and a special cement based powder B component. The two components are mixed together with a slow speed drill and paddle to form a smooth slurry. The slurry is applied by trowel or brush, in two coats, to horizontal and vertical surfaces and dries to form a hard but flexible waterproof cementitious coating.
This is a ready to use powder premix comprising cement, selected particle size quartz, synthetic resins and special additives. Betec Seal is mixed with water using a slow speed drill and paddle to form a smooth slurry. The slurry is applied by brush or trowel, in two or three coats, to horizontal and vertical surfaces and dries to form a hard, durable, waterproof cementitious coating.
A conformable, swellable polymer/butyl rubber waterstop strip that expands in contact with water. When fully encapsulated by poured concrete, the expansive forces form a seal against concrete faces. The seal resists hydrostatic pressure, stopping water from entering sub structures.
BETEC® NSM mortars are a range of technically advanced, single component, cementitious repair mortars that are fibre reinforced and polymer modified The incorporation of plastic fibres minimises the risk of shrinkage cracking and the polymers ensure density and durability in the hardened mortar.
Bituthene® Liquid Membrane is designed to complement GCP Servicised®sheet systems where liquid applied waterproofing is necessary to ensure watertight continuity. Bituthene Liquid Membrane cures to form a tough seamless rubber like waterproof layer. Typical details suitable for Bituthene Liquid Membrane are: curved, irregular or stepped profiles, pile penetrations, internal corners, flashings round drains, gullies or pipe entries and edge sealing at terminations.
Supercast waterstops are extruded from a high grade PVC compound which has been formulated to give excellent flexibility and longevity characteristics. They are available as straight lengths and factory produced intersections or as a factory prefabricated segment of a network to minimise site jointing.
Renderoc Plug is a rapid setting mortar which is easy to apply to horizontal, vertical or overhead surfaces at a wide range of thicknesses. There are two grades available: Renderoc Plug 1 with an initial set time of approximately 1 minute, and Renderoc Plug 20 with an initial set time of approximately 20 minutes.
