One part low-modulus neutral cure fire rated silicone sealant. For fire protection of curtain walling, building façades, expansion joints and penetration seals, where pipes and cables pass through fire rated structures.
Conbextra HF is used for free flow, non-shrink, cementitious grouting of gap thicknesses 10 to 100 mm. Conbextra HF is supplied as a ready to use dry powder. The addition of a controlled amount of clean water produces a free-flowing grout for gap thicknesses up to 100 mm. In addition the low water requirement ensures high early strength and long-term durability.
Concure WB is a water based concrete curing compound based on a low viscosity wax emulsion. It is supplied as a white emulsion which forms a clear film on drying. When first applied to a fresh cementitious surface the emulsion breaks to form a continuous, non-penetrating white coating. This dries to form a continuous clear film which provides a barrier to moisture loss, ensuring more efficient cement hydration, improved durability and reduced shrinkage.
Conbextra TS is used to grout gap thicknesses 75-500 mm. Applications include grouting thick section voids beneath baseplates; voids around below-ground tanks; large bolt pockets etc.
Conbextra UW is used for free flow or pumped grouting applications underwater or in tidal zones. There will be no significant wash-out of the cement phase. Applications include bridge columns, quay pillars, concrete piling, slipways and dams.
To protect atmospherically exposed reinforced concrete structures from attack by acid gases, chloride ions, oxygen and water, especially where there is a danger of subsequent cracks appearing within the substrate. Dekguard E2000 is suitable for use on all types of structures, including those in coastal environments.
Conbextra GP is used for general purpose, non-shrink cementitious grouting of gap thicknesses 10 to 75 mm. Recommended applications at flowable consistency include stanchion base plates, bolt pockets and void filling. At trowellable consistency Conbextra GP is recommended for bedding load bearing components.
Cemtop products consist of a blend of selected cements and aggregates modified with polymers and flow agents. The products are used in conjunction with Nitoprime 33.The products are supplied as a grey powder which requiresonly the addition of water to produce self smoothing, free flowing material.
Conbextra BB is a ready to use cementitious grout supplied in 25 kg moisture resistant bags. It has been formulated specifically for grouting of bridge bearings and parapet post baseplates. The dry powder is a blend of Portland cements, graded silica sands and additives to which only a controlled amount of clean water is added in situ to produce a highly flowable, non shrink grout.
Conbextra EP is For use in situations where heavy dynamic or mobile loads are encountered, e.g. reciprocating machinery, testing equipment, heavy crane and transporter rails, high speed turbines, centrifuges and drop forges. Also for use in conditions where chemical spillage may be encountered. Typical situations could be met in refineries, electroplating works and chemical plants.
